Hp Compaq 8000 Sff5/8/2021
Adding or removing memory modules while voltage is present may cause irreparable damage to the memory modules or system board.Hardware Reference Guide HP Compaq 8000 Elite Ultra-Slim Desktop Business PC First Edition (November 2009) Document Part Number: 588914-001.WARNING Text set off in this manner indicates that failure to follow directions could result in bodily harm or loss of life.
![]() Hp Compaq 8000 Sff Software Installed InFor a complete listing of the hardware and software installed in the computer, run the diagnostic utility (included on some computer models only). Figure 1-2 Front Panel Components Table 1-1 Front Panel Components Optical Drive System Power LED SD Media Card Reader (optional) Headphone Connector NOTE: When a device is plugged into the MicrophoneHeadphone Connector, a dialog box will pop up asking if you want to use the connector for a microphone line Line-In device or a headphone. When a device is plugged into the blue Line-In Audio Connector, a dialog box will pop up asking if you want to use the connector for a line-in device or a microphone. Using the Windows Logo Key Use the Windows Logo key in combination with other keys to perform certain functions available in the Windows operating system. No tools are needed for most of the installation procedures described in this chapter. Warnings and Cautions Before performing upgrades be sure to carefully read all of the applicable instructions, cautions, and warnings in this guide. Connect the round end of the power cord to the power supply connector on the rear of the computer (1). Remove all removable media, such as compact discs or USB flash drives, from the computer. Turn off the computer properly through the operating system, then turn off any external devices. Disconnect the power cord from the power outlet and disconnect any external devices. Figure 2-3 Replacing the Computer Access Panel Chapter 2 Hardware Upgrades. Figure 2-5 Replacing the Front Bezel Replace the access panel. Push the two retaining tabs that hold the bezel blank in place towards the outer left edge of the bezel (1) and pull the bezel blank inwards to remove it (2). SODIMMs The memory sockets on the system board can be populated with up to two industry-standard SODIMMs. These memory sockets are populated with at least one preinstalled SODIMM. Regardless of the power-on state, voltage is always supplied to the memory modules as long as the computer is plugged into an active AC outlet.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |